BUILDING A BETTER WORLD

Home

Examples

Panel Deck

Technical

VBuck

Safe Rooms

Training
Home
About PolySteel
Examples
Panel Deck
Technical
VBuck
1 Introduction
2 Typical Detail
3 For Doors
4 Larger Doors
5 Hardware
6 Install Photos
Safe Rooms
Training
Accessories
Site Map
Contact
Links
VBuck Splicing Hardware

vb15.gif (2728 bytes)
Splice - Insert two 10"-12" pieces of Splice into outside chambers of V-Buck II. Secure with self-drilling fasteners.
The Variable Corner can be used to make a trapezoid, hexagon, octagon etc.  Cut V-Buck II to the desired angle and insert the Variable Corner.

vb16.gif (2164 bytes)

 vb17.gif (3678 bytes)
Use Center Connectors at each corner when using V-Buck products greater than 8" wide.

vb18.gif (1198 bytes)
Half Round - Attach the Half Round using the Splice and securing with self-drilling fasteners. Brace as indicated below.

vb19.gif (11155 bytes)

 

Please report problems to info@polysteelnortheast.com © Polysteel Northeast, LLC 2000. All Rights Reserved.
No part of this website may be reproduced or used without express and written permission from the owner.
Polysteel® and Polysteel Form® are registered trademarks of American Polysteel Forms.